Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 669

Example Supported Releases 2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. OS10(conf-router-bgp-10)# cluster-id 3.3.3.3 10.3.0E or later bgp dampening Enables BGP route-flap dampening and configures the dampening parameters. Syntax Parameters bgp dampening [half-life | reuse-limit | suppress-limit | max-suppress-time | route-map-name] ● half-life - (Optional) Enter the half-life time, in minutes, after which the penalty decreases. After the router assigns a penalty of 1024 to a route, the penalty decreases by half after the half-life period expires, from 1 to 45. ● reuse-limit - (Optional) Enter a reuse-limit value, which compares to the flapping route's penalty value. If the penalty value is less than the reuse value, the flapping route advertises again and is not suppressed, from 1 to 20000. ● suppress-limit - (Optional) Enter a suppress-limit value, which compares to the flapping route's penalty value. If the penalty value is greater than the suppress value, the flapping route is no longer advertised, from 1 to 20000. ● max-suppress-time - (Optional) Enter the maximum number of minutes a route is suppressed, from 1 to 255. ● route-map-name - (Optional) Enter the name of the route-map. Defaults Command Mode Usage Information Example half-life 15; reuse-limit 750; suppress-limit 2000; max-suppress-time 60 ROUTER-BGP-AF To reduce the instability of the BGP process, setup route flap dampening parameters. After setting up the dampening parameters, clear information about route dampening and return the suppressed routes to the Active state. You can also view statistics on route flapping or change the path selection from Default Deterministic mode to Non-Deterministic mode. The no version of this command resets the value to the default. OS10(conf-router-bgpv4-af)# dampening 2 751 2001 51 map1 Supported Releases 10.3.0E or later debug ip bgp Enables Border Gateway Protocol (BGP) debugging and displays messages related to processing of BGP. Syntax debug ip bgp Parameters None Defaults None Command Modes EXEC Usage Information The debug ip bgp command does not display the logs on the console. they are saved in the journal log. The no debug ip bgp command stops displaying messages related to processing of BGP. Example OS10# debug ip bgp Layer 3 669