Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 1370

Usage Information Example Supported Releases If the trust map does not define DSCP values to any traffic class, those flows map to the default traffic class 0. If some of the DSCP values are already mapped to an existing traffic class, you will see an error. The no version of this command returns the value to the default. OS10(conf-tmap-dscp-qos)# qos-group 5 dscp 42 10.3.0E or later qos-map traffic-class Creates a user-defined trust map for queue mapping. Syntax Parameters Default Command Mode Usage Information Example qos-map traffic-class map-name map-name - Enter the name of the queue trust map. A maximum of 32 characters. Not configured CONFIGURATION If applied on the interface or system level, the traffic class routes all traffic to the mapped queue. The no version of this command returns the value to the default. OS10(config)# qos-map traffic-class queue-map1 OS10(config-qos-map)# queue 1 qos-group 5 OS10(config-qos-map)# queue 2 qos-group 6 OS10(config-qos-map)# queue 3 qos-group 7 OS10(config-qos-map)# Supported Releases 10.3.0E or later qos-rate-adjust Configures additional number of data bytes to add to overhead fields per frame for rate calculations. Syntax Parameters Default Command Mode Usage Information Example qos-rate-adjust [value-of-adjust] value-of-adjust-Number of bytes to add to overhead fields in each frame, from 1 to 31. 0 CONFIGURATION The no form of this command removes the rate adjustment configuration and is the same as using the qos-rate-adjust 0 command. OS10(config)# qos-rate-adjust 10 Supported Releases 10.4.3.0 or later queue-limit Configures static or dynamic shared buffer thresholds. Syntax Parameters queue-limit {queue-len value | thresh-mode [dynamic threshold-alpha-value | static threshold-value]} ● queue-len value - Enter the guaranteed size for the queue, from 0 to 8911. 1370 Quality of service