Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 191

Supported Releases 10.5.1.0 or later ptp priority2 Configures the priority2 attribute for advertising PTP clock. Syntax Parameters Defaults Command Mode Security and Access Usage Information ptp priority2 priority-number priority-number-Priority2 has the fifth precedence among the six attributes that are used in the selection of the master clock. Enter a value from 0 to 255. 128 CONFIGURATION Netadmin and sysadmin The lower the value of this attribute, the higher is the priority. The no form of this command removes the configuration. Example OS10(config)# ptp priority2 120 Supported Releases 10.5.1.0 or later ptp role Configures the interface to operate in master, slave, or dynamic role. Syntax Parameters ptp role {dynamic | master | slave} ● master-Enables master role only on the interface ● slave-Enables slave role only on the interface ● dynamic-Enables dynamic role on the interface. The interface can be a master or slave based on the best master clock algorithm (BMCA). Defaults Command Mode Security and Access Usage Information Example Dynamic INTERFACE CONFIGURATION Netadmin and sysadmin If the configuration conflicts with unicast transport mode, this command returns an error. The no form of this command removes the configuration. OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ptp role master Supported Releases 10.5.1.0 or later ptp source Configures the source IP address for the PTP multicast packets. Syntax Parameters ptp source {ipv4 ipv4-address | ipv6 ipv6-address} ● ipv4-address-Source IPv4 address for the PTP multicast packets ● ipv6-address-Source IPv6 address for the PTP multicast packets System management 191