Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 756

Example Supported Releases network information corresponding to these loopback interfaces is still announced in OSPF LSAs that are sent through other interfaces configured for OSPF. OS10(conf-if-eth1/1/6)# ip ospf passive 10.2.0E or later ip ospf priority Sets the priority of the interface to determine the DR for the OSPF network. Syntax Parameters Default Command Mode Usage Information Example ip ospf priority number number - Enter a router priority number, from 0 to 255. 1 INTERFACE When two routers attached to a network attempt to become the DR, the one with the higher router priority takes precedence. The no version of this command resets the value to the default. OS10(conf-if-eth1/1/6)# ip ospf priority 4 Supported Releases 10.2.0E or later ip ospf retransmit-interval Sets the retransmission time between lost LSAs for adjacencies belonging to the interface. Syntax Parameters Default Command Mode Usage Information Example ip ospf retransmit-interval seconds seconds - Enter a value in seconds as the interval between retransmission, from 1 to 3600. 5 seconds INTERFACE Set the time interval to a number large enough to avoid unnecessary retransmission. The no version of this command resets the value to the default. OS10(conf-if-eth1/1/6)# ip ospf retransmit-interval 20 Supported Releases 10.2.0E or later ip ospf transmit-delay Sets the estimated time required to send a link state update packet on the interface. Syntax Parameters Default Command Mode Usage Information ip ospf transmit-delay seconds seconds - Set the time in seconds required to send a link-state update, from 1 to 3600. 1 second INTERFACE When you set the ip ospf transmit-delay value, take into account the transmission and propagation delays for the interface. The no version of this command resets the value to the default. 756 Layer 3