Dell PowerVault MD3620i Owner's Manual - Page 136

associated source virtual disk. Changing the RAID controller module ownership of a virtual disk changes the preferred RAID controller module ownership of the virtual disk. During a virtual disk copy, the same RAID controller module must own both the source virtual disk and the target virtual disk. Sometimes both virtual disks do not have the same preferred RAID controller module when the virtual disk copy starts. Therefore, the ownership of the target virtual disk is automatically transferred to the preferred RAID controller module of the source virtual disk. When the virtual disk copy is completed or is stopped, ownership of the target virtual disk is restored to its preferred RAID controller module. If ownership of the source virtual disk is changed during the virtual disk copy, ownership of the target virtual disk is also changed. Under certain operating system environments, it might be necessary to reconfigure the multi-path driver before an I/O path can be used. To change the RAID controller module ownership of a disk group: 1 In the AMW, select the Logical tab and select a disk group. 2 Select Disk Group Change Ownership/Preferred Path. 3 Select the appropriate RAID controller module slot and click Yes to confirm the selection. CAUTION: Possible loss of data access-Changing ownership at the disk group level causes every virtual disk in that disk group to transfer to the other RAID controller module and use the new I/O path. If you do not want to set every virtual disk to the new path, change ownership at the virtual disk level instead. The ownership of the disk group is changed. I/O to the disk group is now directed through this I/O path. NOTE: The disk group might not use the new I/O path until the multi-path driver reconfigures and recognizes the new path. This action usually takes less than 5 minutes. 136 Configuration: Disk Groups and Virtual Disks