Dell S3100 Command Line Reference Guide for the Series 9.110.0 - Page 1225

Command Modes Command History REDIRECT-LIST This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.7(0.0) 9.5(0.1) 9.4(0.0) 8.4.2.1 8.4.2.0 7.7.1.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Added support for the track-id on the S4810, S4820T, S6000, and Z9000. Introduced on the Z9500. Introduced on the S4810, S4820T, S6000, and Z9000. Introduced on the C-Series and S-Series. Introduced on the E-Series. Introduced on the E-Series. seq Configure a filter with an assigned sequence number for the redirect list. Syntax Parameters seq sequence-number {permit | redirect {ip-address | tunnel tunnel-id}[track ] }} {ip-protocol-number | protocol-type} {source mask | any | host ipaddress} {destination mask | any | host ip-address} [bit] [operator]{sourceport source-port| source-port-range start-port - end-port} {destination-port destination-port| destination-port-range start-port - end-port} To delete a filter, use the no seq sequence-number command. sequence-number permit redirect ip-address tunnel tunnel-id track track Enter a number from 1 to 65535. Enter the keyword permit assign the sequence to the permit list. Enter the keyword redirect to assign the sequence to the redirect list. Enter the keyword IP address of the forwarding router. Enter the keyword tunnel to configure the tunnel setting. Enter the keyword tunnel-id to redirect the traffic. Enter the keyword track to enable the tracking. Enter the keyword track to track object-id. Policy-based Routing (PBR) 1225