Dell S3100 Command Line Reference Guide for the Series 9.110.0 - Page 1774

A system message appears after you enter or delete the virtual-address command. To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual IP address with the same address as the interface's primary IP address and change the priority of the VRRP group to 255. You can ping the virtual IP addresses configured in all VRRP groups. vrrp delay minimum Set the delay time for VRRP initialization after an interface comes up. Syntax vrrp delay minimum seconds Parameters seconds Enter the number of seconds for the delay for VRRP initialization after an interface becomes operational. The range is from 0 to 900 (0 indicates no delay). Defaults Command Modes Command History 0 INTERFACE This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.0.2.0 9.0.0.0 8.3.19.0 8.3.8.0 Description Introduced on the S3148. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the S6000. Introduced on the Z9000. Introduced on the S4820T. Introduced on the S4810. Usage Information This command applies to a single interface. When you use this command with the vrrp delay reload command, the later timer rules VRRP enabling. For example, if vrrp delay reload is 600 and vrrp delay minimum is 300: • When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configured for VRRP. • When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface. Related Command • vrrp delay reload - sets the delay time for VRRP initialization after a system reboot. 1774 Virtual Router Redundancy Protocol (VRRP)