Dell S3100 Command Line Reference Guide for the Series 9.110.0 - Page 244

Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed specifications about entries allowed per ACL, refer to your line card documentation. Prior to 7.8.1.0, names are up to 16 characters long. Example Dell(conf)# mac-access-list access-list extended TestMATExt Dell(config-ext-macl)# remark 5 IPv4 Dell(config-ext-macl)# seq 10 permit any any ev2 eq 800 count bytes Dell(config-ext-macl)# remark 15 ARP Dell(config-ext-macl)# seq 20 permit any any ev2 eq 806 count bytes Dell(config-ext-macl)# remark 25 IPv6 Dell(config-ext-macl)# seq 30 permit any any ev2 eq 86dd count bytes Dell(config-ext-macl)# seq 40 permit any any count bytes Dell(config-ext-macl)# exit Dell(conf)# do show mac accounting access-list snickers interface gig 1/17 in Extended mac access-list snickers on GigabitEthernet 1/17 seq 10 permit any any ev2 eq 800 count bytes (559851886 packets 191402152148 bytes) seq 20 permit any any ev2 eq 806 count bytes (74481486 packets 5031686754 bytes) seq 30 permit any any ev2 eq 86dd count bytes (7751519 packets 797843521 bytes) Related Commands • mac access-list standard - configure a standard MAC access list. • show mac accounting access-list - display MAC access list configurations and counters (if configured). permit To pass packets matching the criteria specified, configure a filter. Syntax permit {any | host mac-address | mac-source-address mac-source-address-mask} {any | host mac-address | mac-destination-address mac-destination-address-mask} [ethertype operator] [count [byte]] | [log] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no permit {any | host mac-address | mac-source-address mac-source- address-mask} {any | mac-destination-address mac-destination-address-mask} command. Parameters any host mac-sourceaddress mac-sourceaddress-mask Enter the keyword any to forward all packets. Enter the keyword host then a MAC address to forward packets with that host address. Enter a MAC address in nn:nn:nn:nn:nn:nn format. (OPTIONAL) Specify which bits in the MAC address must match. The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of 00:00:00:00:00:00 only allows entries that match exactly. mac-destinationaddress Enter the destination MAC address and mask in nn:nn:nn:nn:nn:nn format. 244 Access Control Lists (ACL)