Dell S3100 Command Line Reference Guide for the Series 9.110.0 - Page 714

To return to the default setting, use the no speed {10 | 100 | 1000 | 10000} command. Parameters 10 100 1000 10000 auto Enter the keyword 10 to set the interface's speed to 10 Mb/s. NOTE: This interface speed is not supported on the LC-EH-GE-50P or the LC-EJ-GE-50P card. If the command is entered for these interfaces, an error message appears. Enter the keyword 100 to set the interface's speed to 10/100 Mb/s. NOTE: When this setting is enabled, only 100Base-FX optics are supported on the LC-EH-GE-50P or the LC-EJ-GE-50P card. Enter the keyword 1000 to set the interface's speed to 1000 Mb/s. Auto-negotiation is enabled. For more information, refer to negotiation auto. NOTE: When this setting is enabled, only 1000Base-FX optics are supported on the LC-EH-GE-50P or the LC-EJ-GE-50P card. Enter the keyword 10000 to set the interface's speed to 10000 Mb/s. Auto-negotiation is enabled. For more information, refer to negotiation auto. Enter the keyword auto to set the interface to auto-negotiate its speed. Autonegotiation is enabled. For more information, refer to negotiation auto. Defaults Command Modes Command History auto INTERFACE This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.1) 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.3.1.0 8.1.1.0 7.6.1.0 7.5.1.0 Description Introduced on the S6010-ON and S4048T-ON. Introduced on the S3148. Added support for fanned-out 1 Gigabit SFP port. Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Supported on LC-EH-GE-50P or the LC-EJ-GE-50P cards. Introduced on the E-Series. Introduced on the S-Series. Introduced on the C-Series. 714 Interfaces