Dell S3100 Command Line Reference Guide for the Series 9.110.0 - Page 1369

Version 9.10(0.0) 9.8(1.0) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 pre- 7.7.1.0 Description Introduced on the S3148. Introduced on the Z9100-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Related Commands • router rip - enters ROUTER mode on the switch. distance Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower weights ("administrative distance") are preferred. Syntax distance weight [ip-address mask [prefix-name]] To return to the default values, use the no distance weight [ip-address mask] command. Parameters weight ip-address mask prefix-name Enter a number from 1 to 255 for the weight (for prioritization). The default is 120. (OPTIONAL) Enter the IP address, in dotted decimal format (A.B.C.D), of the host or network to receive the new distance metric. If you enter an IP address, also enter a mask for that IP address, in either dotted decimal format or /prefix format (/x). (OPTIONAL) Enter a configured prefix list name. Defaults Command Modes Command History weight = 120 ROUTER RIP This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) Description Introduced on the S3148. Routing Information Protocol (RIP) 1369