Dell S3100 Command Line Reference Guide for the Series 9.110.0 - Page 988

Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.7.1.0 7.6.1.0 7.4.1.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The advertise dot3-tlv power-via-mdi command enables the system to advertise IEEE 802.3 at power-via-mdi TLV to advertise its power negotiation capabilities with the powered devices via Link Layer Discovery Protocol (LLDP). You can configure this command either on a specific interface or globally. Example Dell(conf)# int gigabitethernet 1/1 Dell(conf-if-gi-1/1)#protocol lldp Dell(conf-if-gi-1/1-lldp)#advertise dot3-tlv power-via-mdi Dell(conf-if-gi-1/1-lldp)#show config ! protocol lldp advertise dot3-tlv power-via-mdi Dell(conf-if-gi-1/1-lldp)# advertise management-tlv Advertise management TLVs (Type, Length, Value). Syntax advertise management-tlv {management-address | system-capabilities | systemdescription | system-name} To remove advertised management TLVs, use the no advertise management-tlv {managementaddress | system-capabilities | system-description | system-name} command. 988 Link Layer Discovery Protocol (LLDP)