Dell S3100 Command Line Reference Guide for the Series 9.110.0 - Page 472

Command Modes Command History ROUTE MAP (config-route-map) This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.7.1.0 7.6.1.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Introduced on the S4820T Introduced on the Z-9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information If the set community rt and soo are in the same route-map entry, the behavior defines as: • If the rt option comes before soo, with or without the additive option, soo overrides the communities rt sets. • If the rt option comes after soo, without the additive option, rt overrides the communities soo sets. • If the rt with the additive option comes after soo, rt adds the communities soo sets. Related Commands • set extcommunity soo - set the extended community site-of-origin in the route-map. set extcommunity soo To set extended community site-of-origin in Route Map, use this feature. Syntax Parameters set extcommunity soo {as4 ASN4:NN | ASN:NNNN | IPADDR:NN [non-trans]} To delete the site-of-origin community, use the no set extcommunity command. as4 ASN4:NN ASN:NNNN IPADDR:NN Enter the keyword as4 then the 4-octet AS specific extended community number in the format ASN4:NN (4-byte AS number:2-byte community value). Enter the 2-octet AS specific extended community number in the format ASN:NNNN (2byte AS number:4-byte community value). Enter the IP address specific extended community in the format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte community value). 472 Border Gateway Protocol