Dell S4148U-ON EMC Networking FCoE Deployment with S4148U-ON in NPG Mode - Page 21

6 6.1 6.2 S4148U-ON validation After configuring connected devices, many commands are available to validate the network configuration. This section provides a list of the most common commands and their output for this topology. Note: The commands and output shown below are for S4148U-Leaf1. The output for S4148U-Leaf2 is similar. For additional commands and output related to the leaf-spine portion of the topology, such as VLT, BGP, etc., see Dell EMC Networking Layer 3 Leaf-Spine Deployment and Best Practices with OS10EE. show interface status The show interface status | grep up command is used to verify required interfaces are up, and links are established at their appropriate speeds. S4148U-Leaf1# show interface status | grep up Port Description Status Speed Fc 1/1/1 To SPB up 16G Fc 1/1/3 To SPA up 16G Eth 1/1/25 Z9264F-Spine1.. up 100G Eth 1/1/26 Z9264F-Spine2.. up 100G Eth 1/1/29 VLTi up 100G Eth 1/1/30 VLTi up 100G Eth 1/1/31 Server 1 up 10G Eth 1/1/32 Server 2 up 10G Eth 1/1/33 Server 3 up 10G Eth 1/1/34 Server 4 up 10G Eth 1/1/41 up 10G Duplex auto auto full full full full full full full full full Mode Vlan Tagged-Vlans T 1 1001,1612-1616 T 1 1001,1612-1616 T 1 1001,1612-1616 T 1 1001,1612-1616 T 1 1001 show fc switch The show fc switch command verifies the switch is in NPG mode. S4148U-Leaf1# show fc switch Switch Mode : NPG Switch WWN : 10:00:e4:f0:04:81:46:cc 21 Dell EMC Networking FCoE Deployment with S4148U-ON in NPG Mode