Dell TL4000 User Guide - Page 261

5. Add the /LUNS switch to the load line of the appropriate SCSI driver. If a dual channel card is installed and you are unsure which channel the LUN device is attached to, edit both lines. LOAD ADPT160M.HAM SLOT=201 /LUNS LOAD ADPT160M.HAM SLOT=202 /LUNS 6. After the STARTUP.NCF file is edited, save the file and reboot the server to activate the new STARTUP.NCF. 7. Upon reboot, navigate to the System Console and type scan all. This action starts a scan of all the LUNS on each adapter. 8. When the scan is complete, verify the LUN device is detected with the list storage adapters command. Typical output with both the tape drive and loader that is recognized: 0x08 [V321-A3] Adaptec SCSI Card 39160/3960D - Ultra160 SCSI [slot 201] 0x16 [V321-A3-D5:1] DELL PV-124T 0031 0x15 [V321-A3-D5:0] IBM ULT3580-TD3 5BG2 0x09 [V321-A4] Adaptec SCSI Card 39160/3960D - Ultra160 SCSI [slot 202] NetWare might display unbound device, meaning a driver is not bound to the loader unless a driver from a backup software is loaded. This action does not prevent the backup application from detecting the LUN and binding the appropriate driver. Note: The command scan all must be typed upon OS boot every time. If back up software services automatically start on OS boot, you must disable them, run the scan all command, and re-enable the services. Appendix D. Enabling LUN support in Linux D-3