Dell UP2414Q Dell UltraSharp 24 User's Guide - Page 20

Setting Up the Monitor, Attaching the Stand, Connecting Your Monitor

Get Dell UP2414Q PDF manuals and user guides View all Dell UP2414Q manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Setting Up the Monitor Attaching the Stand NOTE: The stand is detached from monitor when it is shipped from the factory. NOTE: This is applicable for a monitor with a stand. When any other stand is bought, please refer to the respective stand setup guide for set up instructions. To attach the monitor stand: 1. Remove the cover and place the monitor on it. 2. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor. 3. Press the stand till it snaps into its place. Connecting Your Monitor WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions. To connect your monitor to the computer: 1. Turn Off your computer and disconnect the power cable. 2. Connect the black HDMI cable (optional) or the DP (DisplayPort) cable to the corresponding video port on the back of your computer. Do not use all the cables on the same computer. Use all of the cables only when they are connected to different computers with appropriate video systems. 20  Setting Up the Monitor

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
20
Setting Up the Monitor
Setting Up the Monitor
Attaching the Stand
NOTE:
The stand is detached from monitor when it is shipped from the
factory.
NOTE:
This is applicable for a monitor with a stand. When any other
stand is bought, please refer to the respective stand setup guide for set
up instructions.
To attach the monitor stand:
1.
Remove the cover and place the monitor on it.
2.
Fit the two tabs on the upper part of the stand to the groove on the
back of the monitor.
3.
Press the stand till it snaps into its place.
Connecting Your Monitor
WARNING:
Before you begin any of the procedures in this section,
follow the
Safety Instructions
.
To connect your monitor to the computer:
1.
Turn Off your computer and disconnect the power cable.
2.
Connect the black HDMI cable (optional) or the DP (DisplayPort)
cable to the corresponding video port on the back of your computer.
Do not use all the cables on the same computer.
Use all of the cables only when they are connected to different
computers with appropriate video systems.