Dell Vostro 16 5635 Owners Manual - Page 53
About this task, Steps, Lift the RJ45 network-port assembly off the I/O board.
![]() |
View all Dell Vostro 16 5635 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
About this task NOTE: Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer. NOTE: The I/O board includes a RJ45 network-port assembly. If you are replacing the I/O board, ensure that you remove the RJ45 network-port assembly from the old I/O board and install it in the new I/O board. The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure. Steps 1. Remove the three screws (M2x5) that secure the RJ45 network-port assembly to the I/O board. 2. Lift the RJ45 network-port assembly off the I/O board. 3. Peel the tape that secures the I/O-board cable connector latch to the I/O board. 4. Open the latch and disconnect the power-button board cable from the I/O board. 5. Open the latch and disconnect the fingerprint-reader cable from the I/O board. Removing and installing Field Replaceable Units (FRUs) 53
![](/manual_guide/products/dell-vostro-16-5635-owners-manual-5d85b0b/53.png)