Dell Vostro 16 5635 Owners Manual - Page 67
Installing the system board, Prerequisites
View all Dell Vostro 16 5635 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
13. Open the latch and disconnect the I/O board cable from the system board 14. Disconnect the fan cable from the system board. 15. Remove the two screws (M2x1.8) that secure the system board to the palm-rest and keyboard assembly. 16. Lift the system board at angle off the palm-rest and keyboard assembly, to clear the ports from the port openings. Installing the system board Prerequisites CAUTION: The information in this section is intended for authorized service technicians only. If you are replacing a component, remove the existing component before performing the installation process. About this task The following image(s) indicate the location of the system board and provides a visual representation of the installation procedure. 1. Display cable connector 2. Power-cable connector 3. Battery-cable connector 4. Keyboard-cable connector 5. Touchpad-cable connector 6. Keyboard-backlight cable connector 7. Speaker cable connector 8. I/O board-cable connector 9. Fan-cable connector NOTE: The system board can be removed and installed along with the heat sink, when you replace the palm-rest and keyboard assembly. This simplifies the removal and installation procedure and also prevents damage to the thermal bond between the system board and heat sink. Removing and installing Field Replaceable Units (FRUs) 67