Dell Vostro 5415 Vostro 14 5415 Service Manual - Page 36
Installing the network-port bracket
View all Dell Vostro 5415 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Steps 1. Remove the two screws (M2.5x5) that secure the left-display hinge to the I/O board. 2. Pry open the left-display hinge at an angle of 90 degrees. 3. Remove the two screws (M2x5) that secure the network-port bracket to the I/O board. 4. Lift the network-port bracket off the I/O board. Installing the network-port bracket Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following image(s) indicate the location of the network-port bracket and provides a visual representation of the installation procedure. 36 Removing and installing components
Steps
1.
Remove the two screws (M2.5x5) that secure the left-display hinge to the I/O board.
2.
Pry open the left-display hinge at an angle of 90 degrees.
3.
Remove the two screws (M2x5) that secure the network-port bracket to the I/O board.
4.
Lift the network-port bracket off the I/O board.
Installing the network-port bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the network-port bracket and provides a visual representation of the installation
procedure.
36
Removing and installing components