Dell Vostro 5415 Vostro 14 5415 Service Manual - Page 51
System board, Removing the system board
![]() |
View all Dell Vostro 5415 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Steps 1. Connect the power-adapter port cable to the system board. 2. Adhere the tape that covers the power-adapter port connector on the system board. 3. Route the power-adapter port cable through the routing guides on the palm-rest and keyboard assembly. 4. Place the power-adapter port into the slot on the palm-rest and keyboard assembly. 5. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board. 6. Replace the two screws (M2.5x5) that secures the right-display hinge to the system board. Next steps 1. Install the base cover. 2. Follow the procedure in After working inside your computer. System board Removing the system board Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the base cover. 3. Remove the 3-cell battery or the 4-cell battery, whichever applicable. 4. Remove the M.2 2230 solid-state drive. 5. Remove the M.2 2280 solid-state drive. 6. Remove the memory. 7. Remove the wireless card. 8. Remove the heat sink. About this task The following image indicates the connectors on your system board. Removing and installing components 51
![](/manual_guide/products/dell-vostro-5415-vostro-14-5415-service-manual-e873a25/51.png)