Dell Vostro 5415 Vostro 14 5415 Service Manual - Page 46
Installing the display assembly, Steps, To avoid damaging the display
![]() |
View all Dell Vostro 5415 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Steps 1. Peel the tape that secures the display-cable connector latch to the system board. 2. Lift the latch and disconnect the display-cable from the connector on the system board. 3. Remove the two screws (M2.5x5) that secure the right-display hinge to the system board. 4. Pry open the right-display hinge at an angle of 90 degrees. 5. Remove the two screws (M2.5x5) that secure the left-display hinge to the I/O board. 6. Pry open the left-display hinge at an angle of 90 degrees. 7. Gently lift the palm-rest and keyboard assembly off the display assembly CAUTION: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly. Installing the display assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following image(s) indicate the location of the display assembly and provides a visual representation of the installation procedure. 46 Removing and installing components
![](/manual_guide/products/dell-vostro-5415-vostro-14-5415-service-manual-e873a25/46.png)