Dell Vostro 5415 Vostro 14 5415 Service Manual - Page 47

Steps, To avoid damaging the display

Get Dell Vostro 5415 PDF manuals and user guides View all Dell Vostro 5415 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 47 highlights

Steps 1. Place the display assembly on a clean and flat surface with the display panel facing up. 2. Gently place the palm-rest and keyboard assembly under the display hinges. CAUTION: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly. 3. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board. 4. Replace the two screws (M2.5x5) that secure the left-display hinge to the palm-rest and keyboard assembly. 5. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board. 6. Replace the two screws (M2.5x5) that secure the right-display hinge to the palm-rest and keyboard assembly. 7. Connect the display cable to the connector on the system board and close the latch. 8. Adhere the tape that secures the display-cable connector latch to the system board. Removing and installing components 47

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
Steps
1.
Place the display assembly on a clean and flat surface with the display panel facing up.
2.
Gently place the palm-rest and keyboard assembly under the display hinges.
CAUTION:
To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.
3.
Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
4.
Replace the two screws (M2.5x5) that secure the left-display hinge to the palm-rest and keyboard assembly.
5.
Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
6.
Replace the two screws (M2.5x5) that secure the right-display hinge to the palm-rest and keyboard assembly.
7.
Connect the display cable to the connector on the system board and close the latch.
8.
Adhere the tape that secures the display-cable connector latch to the system board.
Removing and installing components
47