Dell W-7205 Controller Installation Guide - Page 16

Serial Console Port Adapter, Micro-USB Console Port, Micro-USB Driver, Management Port

Page 16 highlights

CAUTION: The Console port is compatible only with RS-232 devices. Non-RS-232 devices, such as APs, are not supported. CAUTION: Do not connect the Console port to an Ethernet switch or a PoE power source. This may damage the controller. ATTENTION: Le port CONSOLE est compatible uniquement avec les périphériques RS-232. Les périphériques qui ne sont pas de type RS-232, notamment les points d'accès, ne sont pas pris en charge. ATTENTION: Ne connectez pas le port Console sur un commutateur Ethernet ou une source d'alimentation PoE. Sinon, vous risquez d'endommager le contrôleur. Serial Console Port Adapter A modular adapter can be used to convert the female RJ-45 connector on the front (see Figure 5) to a male DB9 connector. See Figure 6 for details. Figure 6 RJ-45 (Female) to DB9 (Male) Modular Adapter Conversion RJ-45 Female Pin-Out 1 2 3 TxD 4 5 GND 6 RxD 7 8 Internal Connections RJ-45 3 TxD 4 5 GND 6 RxD DB-9 2 5 3 DB-9 Male Pin-Out 9 8 7 6 5 Ground 4 3 RxD 2 TxD 1 Micro-USB Console Port The W-7205 controller is equipped with one Micro-USB (type B) connector on the front (see Figure 4) that provides console access for direct local management. If both Micro-USB and RJ-45 Console ports are connected, the Micro-USB connection takes precedence over the RJ-45 Console connection. Micro-USB Driver To use the Micro-USB console port, install the Micro-USB driver on the system that will manage the controller. The driver is available for download on download.dell-pcw.com under Tools & Resources . Management Port The W-7205 controller is equipped with a 10/100/1000BASE-T Gigabit Management (RJ-45) port on the front (see Figure 4). The management port provides 10/100/1000 Mbps Ethernet access to the controller CLI, SNMP, and Web interface for complete system management and troubleshooting. It can also be used to connect to a separate management network. The management port has a LINK/ACT LED on its top left and SPEED LED on its top right. During operation, these LEDs provide the status information as shown in the following table: Table 11: 10/100/1000BASE-T (RJ-45) Management Port LED Function Indicator LINK/ACT Link Status Green (Solid) Green (Blinking) Off SPEED Interface Speed Green (Solid) Off Status Link established Link activity No link on port 1000 Mbps 10/100 Mbps 16 | W-7205 Controller Dell Networking W-7205 Controller | Installation Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

16
|
W-7205 Controller
Dell Networking W-7205 Controller
|
Installation Guide
CAUTION: The Console port is compatible only with RS-232 devices. Non-RS-232 devices, such as APs, are not supported.
CAUTION: Do not connect the Console port to an Ethernet switch or a PoE power source. This may damage the controller.
ATTENTION: Le port CONSOLE est compatible uniquement avec les périphériques RS-232. Les périphériques qui ne sont pas de type
RS-232, notamment les points d’accès, ne sont pas pris en charge.
ATTENTION: Ne connectez pas le port Console sur un commutateur Ethernet ou une source d’alimentation PoE. Sinon, vous risquez
d’endommager le contrôleur.
Serial Console Port Adapter
A modular adapter can be used to convert the female RJ-45 connector on the front (see
Figure 5
) to a male DB9
connector. See
Figure 6
for details.
Figure 6
RJ-45 (Female) to DB9 (Male) Modular Adapter Conversion
3
4
5
2
5
6
3
RJ-45
DB-9
Internal
Connections
TxD
GND
RxD
1
2
3
4
5
6
7
8
TxD
GND
RxD
RJ-45 Female
Pin-Out
DB-9 Male
Pin-Out
TxD
RxD
Ground
5
4
3
2
1
9
8
7
6
Micro-USB Console Port
The W-7205 controller is equipped with one Micro-USB (type B) connector on the front (see
Figure 4
) that
provides console access for direct local management. If both Micro-USB and RJ-45 Console ports are connected, the
Micro-USB connection takes precedence over the RJ-45 Console connection.
Micro-USB Driver
To use the Micro-USB console port, install the Micro-USB driver on the system that will manage the controller. The
driver is available for download on
download.dell-pcw.com
under Tools & Resources .
Management Port
The W-7205 controller is equipped with a 10/100/1000BASE-T Gigabit Management (RJ-45) port on the front (see
Figure 4
). The management port provides 10/100/1000 Mbps Ethernet access to the controller CLI, SNMP, and
Web interface for complete system management and troubleshooting. It can also be used to connect to a separate
management network. The management port has a LINK/ACT LED on its top left and SPEED LED on its top
right. During operation, these LEDs provide the status information as shown in the following table:
LED
Function
Indicator
Status
LINK/ACT
Link Status
Green (Solid)
Link established
Green (Blinking)
Link activity
Off
No link on port
SPEED
Interface Speed
Green (Solid)
1000 Mbps
Off
10/100 Mbps
Table 11:
10/100/1000BASE-T (RJ-45) Management Port