Dell W-7205 Controller Installation Guide - Page 24

ATTENTION: Chaque contrôleur W-7205 doit disposer de son propre équipement de montage. Veillez à ne placer aucun autre équipement réseau directement sur un contrôleur W-7205 installé. Dans le cas contraire, vous risqueriez d'endommager le périphérique. Required Tools and Equipment The following tools and equipment are required for installing a W-7205 controller from the middle of the device: l Mid-mount brackets (x2) (included in the mounting accessory kit) l Screws for the mounting brackets (x8): M4 x 8 mm Phillips Flat Head Screws l Screws for system rack mount (x4): M6 x 15 mm Phillips Pan Head Screws l M6 cage nut (x4): Optional l M6 clip nut (x4): Optional l Suitable screwdrivers (not included in the package) NOTE: Some racks require screws that differ from those included with the W-7205 controller. Ensure to have the correct screws before installing the W-7205 controller. Installation Steps To install a W-7205 controller from the middle in a standard two-point 19-inch rack system: 1. Place the mid-mount brackets over the mounting holes on either side of the controller in the middle (see Figure 9). Figure 9 Attaching the Mid-Mount Brackets 2. Secure the brackets to the controller using the eight screws for mounting bracket (four per bracket) and a suitable screwdriver. 3. If the rack requires cage nuts or clip nuts, insert them on the front rails (two per rail, aligned horizontally) 4. Mount the controller in the rack using the four screws for system rack mount (two per bracket) and suitable screwdriver (see Figure 10). 24 | Installation Dell Networking W-7205 Controller | Installation Guide