Dell W-7205 Controller Installation Guide - Page 23
Installation Steps, Rack Mount Installation- Mid
View all Dell W-7205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Installation Steps To install a W-7205 controller from the front in a standard two-post 19-inch Telco rack: 1. Place the mounting brackets over the mounting holes near the front on either sides of the controller (see Figure 7). Figure 7 Attaching the Mounting Brackets 2. Secure the brackets to the controller using the eight screws for the mounting bracket (four per bracket) and a suitable screwdriver. 3. If the rack requires cage nuts or clip nuts, insert them on the front rails (two per rail, aligned horizontally) 4. Mount the controller in the rack using the four screws for system rack mount (two per bracket) and a suitable screwdriver (see Figure 8). Figure 8 Front-Rack Mount Installation NOTE: Leave a minimum of 10 cm (4 inches) of space on the left and right side of the controller for proper air flow and ventilation. Leave additional space in the front and the back of the controller to access network cables, LED status indicators, and power cord. Rack Mount Installation- Mid An optional accessory kit (SPR-WL2-MNT, must be purchased separately) is available that allows mounting the W7205 controller from the middle in standard two-post 19-inch Telco rack. CAUTION: Each W-7205 controller must have its own mounting equipment. Do not place other networking equipment directly on top of a mounted W-7205 controller. Failure to do so can damage the controller. Dell Networking W-7205 Controller | Installation Guide Installation | 23