Dell W-7205 Controller Installation Guide - Page 28
Disconnecting the AC Power Cord, Installing an SFP/SFP+ Module, Connecting an LC Fiber Optic Cable
View all Dell W-7205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Disconnecting the AC Power Cord To disconnect the AC power cord from the W-7205 controller: 1. Lift the power cord retaining clip off the AC power cord. 2. Pull the AC power cord from the AC connector. 3. The W-7205 controller is now turned Off. Installing an SFP/SFP+ Module NOTE: Use standard ESD precautions when installing or removing an SFP/SFP+ module. To install an SFP/SFP+ module into the W-7205 controller: 1. Slide the SFP/SFP+ module, top side facing upward, into a 10GBASE-X or 1000BASE-X ports on the controller until a connection is made and an audible click is heard (see Figure 14). Figure 14 Installing an SFP Module Connecting an LC Fiber Optic Cable To connect an LC fiber optic cable into an SFP-SX or SFP-LX module: 1. Clean the fiber optic cable connector before inserting it into the SFP/SFP+ module. 2. Insert the fiber optic cable into the SFP/SFP+ module. Ensure that the latch on the cable faces the top of the SFP/SFP+ module (see Figure 15). 3. Slide the cable into place until a connection is made and an audible click is heard. 28 | Installation Dell Networking W-7205 Controller | Installation Guide