Dell W-Series 334 Instant 6.5.1.0-4.3.1.0 User Guide - Page 83

(Instant AP)(SSID Profile )# max-clients-threshold (Instant AP)(SSID Profile )# end (Instant AP)# commit apply Temporal Diversity and Maximum Retries using CLI Starting from Instant 6.5.0.0-4.3.0.0, when clients are not responding to 802.11 packets with the temporaldiversity parameter disabled, which is the default setting, W-IAPs can attempt only hardware retries. But if this parameter is enabled when the clients are not responding to 802.11 packets, W-IAPs can perform two hardware retries. When the hardware retry attempts fail, W-IAPs can perform software retries. The max-retries parameter indicates the maximum number of attempts the W-IAP performs when clients are not responding to 802.11 packets. By default, the W-IAP attempts a maximum of eight retries when clients are not responding to 802.11 packets. The following example shows the configuration of temporal-diversity and max-retries in a WLAN SSID profile: (Instant AP) (config) # wlan ssid-profile Name (Instant AP) (SSID Profile "Name") # temporal-diversity (Instant AP) (SSID Profile "Name") # max-retries 3 (Instant AP) (SSID Profile "Name") # end (Instant AP) # commit apply Configuring VLAN Settings for a WLAN SSID Profile If you are creating a new SSID profile, complete the WLAN Settings procedure before configuring the VLAN. For more information, see Configuring WLAN Settings for an SSID Profile on page 78. You can configure VLAN settings for an SSID profile using the Instant UI or the CLI. In the Instant UI To configure VLAN settings for an SSID: 1. On the VLAN tab of the New WLAN window, perform the following steps. The following figure displays the contents of the VLAN tab. Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide Wireless Network Profiles | 83