Denon 4802R Owners Manual - Page 48
Example: Stereo, DOLBY DIGITAL
UPC - 081757505345
View all Denon 4802R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
3 Select the play mode. Example: Stereo STEREO (Main unit) (Remote control unit) 4 Start playback on the selected component. • For operating instructions, refer to the component's manual. 5 Adjust the volume. MASTER VOLUME The volume level is displayed on the master volume level display. (Main unit) (Remote control unit) The volume can be adjusted within the range of -70 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is set as described on page 23 or page 56, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume adjustment range is "18 dB - (Maximum value of channel level)".) Input mode when playing DTS sources • Noise will be output if DTS-compatible CDs or LDs are played in the "ANALOG" or "PCM" mode. When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to "AUTO" or "DTS". Input mode display • In the AUTO mode INPUT MODE AUTO PCM DTS • In the PCM mode INPUT MODE AUTO PCM DTS • In the DTS mode INPUT MODE AUTO PCM DTS • In the ANALOG mode INPUT MODE AUTO PCM DTS Input signal display • DOLBY DIGITAL SIGNAL DIGITAL PURE DIRECT • DTS SIGNAL DIGITAL PURE DIRECT One of these lights, depending on the input signal. ANALOG DIGITAL DIGITAL DIGITAL ANALOG This lights, depending on the input signal. PRO LOGIC DIGITAL DIGITAL SIGNAL DIGITAL PURE DIRECT DIGITAL The DIGITAL indicator lights when digital signals are being input properly. If the DIGITAL indicator does not light, check whether the digital input component setup (page 28) and connections are correct and whether the component's power is turned on. NOTE: • The DIGITAL indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard. 48