Denon AVP-A1HDCI Owners Manual - English - Page 44
XLR Out Polarity, POA Setting, Source Delete, Volume Control
![]() |
UPC - 883795000802
View all Denon AVP-A1HDCI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications s XLR Out Polarity Set to switch the XLR pre-out terminal polarity. [Selectable channels] Front L Front R Center Surround A L Surround A R Surround B L Surround B R Surround Back L Surround Back R Subwoofer 1 Subwoofer 2 Subwoofer 3 [Selectable items] XLR XLR (INV) qGROUND wHOT eCOLD qGROUND wCOLD eHOT POA 1/POA 2 Mute Level Set POA-A1HDCI for which the MODE select switch is set to "1" or This sets the amount of attenuation of the volume when the mute "2". mode is set in the MAIN ZONE. See the POA-A1HDCI operating instructions. [Selectable items] Full -40dB -20dB n Input Selector Select the setup channel. [Selectable items] L1 R1 L2 R2 L3 R3 L4 R4 L5 R5 g Source Delete Remove input sources that are not used from the display. [Selectable items] ON Delete Select the connector input to be used for each channel. [Selectable items] RCA XLR OFF n Power Amp Select the setup channel. NOTE • Input sources being used in the various zones cannot be deleted. • Input sources set to "Delete" cannot be selected from GUI menu "Source Select" or using the SOURCE SELECT knob on the main unit or SOURCE SELECT button on the remote control unit. d POA Setting Set when connecting the receiver to a POA-A1HDCI. [Selectable items] L1/L2 L3/L4 L5/R5 R1/R2 R3/R4 Set the power amp usage for each channel. [Selectable items] NORMAL BI-AMP BRIDGE (BTL) h GUI Make GUI related settings. POA LINK Set when connecting the receiver to a POA-A1HDCI through a CONTROL LINK. [Selectable items] OFF ON (Single) ON (Dual) LINK Check Check CONTROL LINK. f Volume Control Set the MAIN ZONE volume setting. Volume Limit Make a setting for maximum volume. [Selectable items] OFF -20dB -10dB 0dB Power On Level This sets the volume set when the MAIN ZONE's power is turned on. Screensaver Make screensaver settings. Use the screensaver to prevent burn-in on the monitor screen. When set to "ON", the screensaver is activated if there is no activity for about 3 minutes. [Selectable items] ON OFF Wall Paper Change the GUI background. [Selectable items] Picture Black Gray Blue Format Select the video output signal format to match the monitor. [Selectable items] NTSC PAL [Selectable items] Last - - -dB -80dB ~ 18dB NOTE When a format other than the video format of the connected monitor is set, the picture will not be displayed properly. Use the procedure described below to change the video format. 41
![](/manual_guide/products/denon-avpa1hdci-owners-manual-english-9f90e0c/44.png)