Dynex DX-26LD150A11 User Manual (English) - Page 8
Installing and removing the, stand - tv stand
UPC - 600603127205
View all Dynex DX-26LD150A11 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
4 DX-26LD150A11/DX-32LD150A11 Installing and removing the stand Installing and removing the stand If you plan to use your TV/DVD combo in an upright position on a flat surface, you must install your TV/DVD combo into the stand. If you intend to mount your TV/DVD combo on a wall or other vertical surface, you must remove the stand and stand column. Warning: Before attempting assembly or removal of the stand, unplug the AC power cord. Cautions: Read these instructions thoroughly before attempting this installation. Make sure that you handle your TV/DVD combo very carefully when attempting assembly or removal of the stand. If you are not sure of your ability to do this, or to use the tools necessary to complete this job, refer to a professional installer or service personnel. The manufacturer is not responsible for any damages or injuries that occur due to mishandling or improper assembly. When using a table or bench as an aid to assembly, make sure that you place the TV/DVD combo on a soft cushion or covering to prevent accidental scratching or damage to your TV/DVD combo's finish. Installing the stand (DX-26LD150A11) You need to install the stand to use the TV/DVD combo in the upright position on a flat surface. To install the stand (DX-26LD150A11): 1 Remove the stand from the box and place it on a table or bench. 2 Secure the stand to the stand column with the four screws with washers provided. 4 Slide the stand column into the slot in the bottom of the TV/DVD combo. Stand 5 Secure the stand with the five screws and washers provided. Stand screws (M4*10) with washers Stand Stand screws (M4*8) with washers 3 Lay your TV/DVD combo face down on a soft, dry, lint free surface so that your TV/DVD combo is not scratched. Align the bottom side of the TV/DVD combo with one edge of the table. 6 Place your TV/DVD combo in an upright position on a flat surface. Installing the stand (DX-32LD150A11) You need to install the stand to use the TV/DVD combo in the upright position on a flat surface. To install the stand (DX-32LD150A11): 1 Remove the stand from the box and place it on a table or bench. 2 Secure the stand column to the stand with the four screws with washers provided. Screws (M4*10) with washers Stand column Stand 3 Lay your TV/DVD combo face down on a soft, dry, and lint free surface. Align the bottom side of the TV/DVD combo with one edge of the table.