Dynex DX-LDVD19-10A User Manual (English) - Page 12
Making connections - problems
UPC - 600603125263
View all Dynex DX-LDVD19-10A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
DX-LDVD19-10A_09-0340.book Page 8 Tuesday, April 28, 2009 4:43 PM 8 DX-LDVD19-10A Making connections Making connections Cautions: Check the terminals for position and type before making any connections. Loose connections can result in image or color problems. Make sure that all connections are tight and secure. The external audio/video equipment shown in these illustrations may be different from your equipment. If you have questions, refer to the user manual that came with your equipment. Always turn the power off when connecting external equipment. Connecting the power To connect the power: • Plug the AC cord into an AC power outlet. Notes: Your TV should only be operated from the power source indicated on the label. Always unplug the AC power cord from the AC power outlet when you will not be using your TV for an extended period of time. Connecting an antenna or cable TV To connect an antenna, cable TV, or satellite TV box: 1 Connect one end of a 75 ohm cable (not included) to the RF OUT jack on the antenna or on the cable or satellite TV box. Multi-family dwellings or apartments Connect to wall antenna outlet. ANT/CABLE IN VHF antenna UHF antenna Wall antenna outlet Bronze wire - do not bend 75 ohm RF coaxial wire Turn clockwise to tighten Bronze wire - do not bend Single-family dwellings or houses Connect to wall antenna jack for outdoor antenna. 2 Connect the other end of the cable to the ANT/CABLE IN jack on the back of your TV. Notes: Use a 75 ohm cable to eliminate interference and noise from radio waves. Do not bundle the 75 ohm cable with the power cord or other cables. If the antenna is not installed correctly, contact qualified service personnel to correct the problem. To improve picture quality in a poor signal area, purchase and install a signal amplifier. Connecting a cable TV or satellite box If you subscribe to a cable TV service from a local provider you can watch cable TV programming. The TV cannot display TV programming unless a TV tuner device or cable TV converter box is connected to the TV. For further information regarding cable TV service, contact your local cable TV service provider(s). To connect to a cable TV or satellite TV box: 1 Connect the incoming cable from the satellite wall jack to the SATELLITE IN jack on the satellite box. HDMI cable S-Video cable 5 $ 8 ' ,2 ,1 / 6 9 ,' ( 2 ,1 5 $ 8 ' ,2 ,1 / 9 ,' ( 2 ,1 +'0 , 2 Depending on the jacks available on the satellite TV receiver (set top box), connect a cable from the outgoing jacks on the satellite box to the corresponding jacks on the back of your TV. The connection can be to the HDMI, component video, S-Video, or AV jack. 3 If you use a component video, S-Video, or AV cable, connect audio cables to the corresponding jacks on the back of your TV and on the staellite box. 4 Turn on your TV, then press INPUT to select VIDEO mode for the type of connection you use. 5 Select the channel you want with the remote control for the cable box. Back of TV Cable box 3U 3E < & 2 0 3 2 1 ( 1 7,1 Component video cables