Epson ActionLaser 1000 User Manual - Page 139
Before you use the optional interface board, you may need
View all Epson ActionLaser 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
7. Insert the interface cable(s) into the U-shaped part of one cable clip. Lift the left side of the printer up slightly. Then hook the short lip of the clip into the forward slot and push the bottom of the clip under the printer until it clicks in place. Repeat this procedure with the second clip and insert it into the back slot. Note: Hook no more than two cables into one cable clip. Never put too much pressure on the cables. 8. Turn the printer around so that the control panel faces you. Make sure the printer is turned off; then plug the power cord into the printer and into an electrical outlet. Before you use the optional interface board, you may need to change the printer emulation and the interface option using SelecType. If your optional interface is parallel and you want to use HP emulation with it, you do not have to change any settings. For settings information, see Chapter 4, "SelecType." Options 5-25