Epson ActionLaser 1000 User Manual - Page 246

The following commands are available in FX emulation but not in LQ emulation: ESC1 ESC^ ESCI 7/72-inch line feed Select 9-pin graphics mode Select character code table The following commands are available in LQ emulation but not in FX emulation: ESC+ Select n/360-inch line spacing The printer commands listed below function in a slightly different way when used in the LQ or FX emulations. Also, many of the commands that control the print position use approximations because of the difference in print density between the LQ and FX printers. ESCG/ESCE These commands produce identical bolding effects on your printer. On an actual LQ series printer, these two commands create slightly different effects and can be combined to produce darker characters. SI/ESC SI These commands print 10 cpi characters in a 16.66 cpi font, and 12 cpi characters in a 20 cpi font. On an actual LQ/FX series printer, these commands condense the font. ESC x This command is normally used to select between draft and LQ quality with an LQ or FX printer. However, this command has no effect on your printer's print quality since all characters are printed at 300 dpi (dots per inch). LQ and FX Emulation Modes C-15