Epson ActionLaser 1000 User Manual - Page 247
ESC w, ESC &, ESC*, and ESC, listed above do not produce exactly the same output on
View all Epson ActionLaser 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 247 highlights
ESC w This command produces double-height characters but differs between LQ and FX emulations, as follows: LQ emulation-If you send the ESC w command when the printer position is set at the first line of the logical page, LQ printers print only the bottom half of the characters. Your printer prints the entire characters. FX emulation-When combining ESC w and ESC W to produce double width, double-height characters, FX printers do not increase the stroke weight for vertical lines. Your printer in FX emulation does increase the vertical line width. Also, when this command is sent with the print position set at the first line of the page, FX printers change the baseline position in order to print the entire character. For your printer, the baseline is not changed. ESC &, ESC K, ESC L, ESC Y, ESC Z, ESC*, and ESC ^ This printer uses an image processing technique that emulates, as closely as possible, the image densities available on FX and LQ printers. Because of this process, the graphics commands listed above do not produce exactly the same output on this printer that they would on an FX or an LQ printer. ESC C, ESC C0 When you send the ESC or ESC CO command to change the page length on the LQ or FX printers, you can print more than one page on the same sheet of paper. Because your printer processes data page-by-page, each page must be printed on a separate sheet of paper, so exact LQ or FX emulation cannot be provided. Problems will occur when the page length set with the ESC C or ESC CO command differs from the actual page length. C-16 LQ and FX Emulation Modes