Epson PhotoPC L-410 Camera Basics - Page 40

The camera does not react when you press the buttons., The camera takes too long to take a photo.

Get Epson PhotoPC L-410 PDF manuals and user guides View all Epson PhotoPC L-410 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

The camera does not react when you press the buttons. ◗ If the lights on the back of the camera are flashing, try turning the camera off and then on again. ◗ If the power does not turn off, remove the battery, reinstall it, and turn the power on. If the lights are still flashing, contact Epson as described on page 45. The camera takes too long to take a photo. If you press the shutter button all the way down, the camera has to focus and set the exposure before the shutter releases. Press and hold the button halfway to set the focus, then press it all the way down to take a photo. The flash doesn't work. ◗ Make sure the flash is not set to (flash off ). ◗ If you're using one of the automatic flash modes, the flash only works when there is insufficient light. The LCD screen is hard to see. Turn the Mode dial to SETUP and adjust the LCD Brightness setting. 40

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
40
The camera does not react when you press the buttons.
If the lights on the back of the camera are flashing,
try turning the camera off and then on again.
If the power does not turn off, remove the battery,
reinstall it, and turn the power on. If the lights are
still flashing, contact Epson as described on page 45.
The camera takes too long to take a photo.
If you press the shutter button all the way down, the
camera has to focus and set the exposure before the
shutter releases. Press and hold the button halfway to set
the focus, then press it all the way down to take a photo.
The flash doesn’t work.
Make sure the flash is not set to
(flash off).
If you’re using one of the automatic flash modes, the
flash only works when there is insufficient light.
The LCD screen is hard to see.
Turn the Mode dial to
SETUP
and adjust the
LCD
Brightness
setting.