Epson Stylus NX200 Quick Guide - Page 35
Close the scanner., Press the, button to begin charging the ink. This takes about
View all Epson Stylus NX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
11. Close the scanner. 12. Press the y Stop button to begin charging the ink. This takes about 2½ minutes. When it's finished, the P On light stops flashing and remains on, and the B ink light goes out. Caution: Never turn off the NX200 Series while ink is charging or you'll waste ink. If the B ink light flashes, press the y Stop button and press down all the cartridges securely. Note: If you replaced a cartridge while copying a document or photo, cancel printing and make sure your original is still placed correctly on the document table. Then copy your original again. If you remove a low or expended ink cartridge, you cannot reinstall and use it. Replacing Ink Cartridges 35
Replacing Ink Cartridges
35
11.
Close the scanner.
12.
Press the
y
Stop
button to begin charging the ink. This takes about
2½ minutes. When it’s finished, the
P
On
light stops flashing and remains
on, and the
B
ink light goes out.
Caution:
Never turn off the NX200 Series while ink is charging or you’ll waste ink. If the
B
ink light flashes, press the
y
Stop
button and press down all the cartridges
securely.
Note:
If you replaced a cartridge while copying a document or photo, cancel printing and
make sure your original is still placed correctly on the document table. Then copy
your original again.
If you remove a low or expended ink cartridge, you cannot reinstall and use it.