Epson WorkForce 500 Quick Guide - Page 37

into place., Insert the new ink cartridge into the holder and push it down until it clicks - ink replacement

Get Epson WorkForce 500 - All-in-One Printer PDF manuals and user guides View all Epson WorkForce 500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

4. Shake the cartridge several times, then remove it from the package. Do not to touch the green chip on the side. 5. Remove the yellow tape from the bottom of the ink cartridge. Caution: Do not remove any other labels or seals, or ink will leak. 6. Insert the new ink cartridge into the holder and push it down until it clicks into place. 7. Once you replace all the cartridges that need replacing, close the cartridge cover and push it down until it clicks into place. 8. Close the scanner. 9. Press OK to begin charging the ink. This takes about 2 minutes. When you see a completion message on the display screen, ink charging is finished. Caution: To conserve ink, never turn off the WorkForce 500 Series while ink is charging. If you see an ink replacement message on the display screen, press OK and press down all the cartridges securely. If you remove a low or expended ink cartridge, you cannot reinstall and use the cartridge. Replacing Ink Cartridges 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
Replacing Ink Cartridges
37
4.
Shake the cartridge several times,
then remove it from the package.
Do not to touch the green chip on
the side.
5.
Remove the yellow tape from the
bottom of the ink cartridge.
Caution:
Do not remove any other labels or seals, or ink will leak.
6.
Insert the new ink cartridge into the holder and push it down until it clicks
into place.
7.
Once you replace all the cartridges that need replacing, close the cartridge
cover and push it down until it clicks into place.
8.
Close the scanner.
9.
Press
OK
to begin charging the ink. This takes about 2 minutes. When you
see a completion message on the display screen, ink charging is finished.
Caution:
To conserve ink, never turn off the WorkForce 500 Series while ink is charging. If you
see an ink replacement message on the display screen, press
OK
and press down all
the cartridges securely.
If you remove a low or expended ink cartridge, you cannot reinstall and use the
cartridge.