Epson r-d1 User Manual - Addendum - firmware version 2.0 upgrade features. - Page 13

Installing the Battery in the Camera 1. Make sure the camera's power switch is in the Off position, then open the battery cover. DUMMY 2. Insert the battery into the camera as far as it will go, making sure the orientation of the battery is correct. DUMMY 3. Close the battery cover until it clicks. Note: You can check the amount of battery power remaining in the camera by checking the status gauge. (See page 10.) Using a Memory Card 1 You cannot take pictures unless a memory card is installed in the camera. The camera accepts SD memory cards of up to 2 GB capacity. c Caution: ❏ Make sure there is no dirt or dust on the memory card terminal. If 1 it is dirty, you may not be able to read from or write to the card. ❏ Never insert or remove a memory card while the memory card 1 access light is on. This may cause data in the card to be lost or damaged, or render the memory card unusable. ❏ Keep the memory card slot cover closed except when you insert or 1 remove the memory card. This protects the memory card and the slot from dust particles and static shock; otherwise data on the memory card may be lost or damaged. 1 ❏ Static shock to the memory card may cause the camera to malfunction. Note: 1 ❏ Be sure to read the documentation included with the card to make sure you use it correctly. 1 ❏ If the memory card has been already formatted with a computer or another digital camera, you may not be able to save images on the card. If this happens, reformat the card using this camera. For instructions, see "Formatting the Memory Card" on page 42. 1 1 1 Getting Started 13