Fluke 225C User Manual - Page 89
Ethernet Twisted Pair/10BaseT/100BaseT, Ethernet Twisted Pair Measurement, Connections
View all Fluke 225C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Ethernet Twisted Pair/10BaseT/100BaseT Default probe setting 10:1. Use the Fluke 10:1 probe. 1 Connect the red probe to test tool input A 2 Connect the probe ground lead to the bus TD+ (RD+) 3 Connect the probe tip to the bus TD- (RD-) RJ-45 1 (3) 2 (6) TD+ (RD+) TD- (RD-) 6 Using The Bushealth Function Input Connections and Tested Signals Table 11. Ethernet Twisted Pair Tested Signal Properties Signal V-Level Data Rise Fall Jitter Signal Dist. Description Peak-Peak voltage Bit width Rise time as % of bit width Fall time as % of bit width Jitter distortion Signal distortion Figure 45. Ethernet Twisted Pair Measurement Connections Note Normally the Ethernet bus has continuous data traffic. Incidentally the bus may have no continuous data traffic. See Data Traffic on page 70. 79