Garmin eTrex Venture HC Owner's Manual - Page 8
Turning on the eTrex, Adjusting the Backlight, Initializing the GPS Receiver
UPC - 753759072872
View all Garmin eTrex Venture HC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Getting Started Turning on the eTrex To turn the eTrex on and off: Press and hold POWER. Adjusting the Backlight To adjust the backlight level: 1. Press and quickly release the POWER key. 2. Press up on the ROCKER to increase the brightness and down to decrease. 3. Press ENTER or QUIT to close. Initializing the GPS Receiver The first time you turn on your eTrex, the GPS receiver must collect satellite data and establish its current location. To receive satellite signals, you must be outdoors and have a clear view of the sky. To initialize your eTrex: Hold the unit in front of you facing the sky. While the GPS receiver is searching for the satellite signals, a "Locating Satellites" message is replaced by an "Acquiring Satellites" message until enough signals are acquired to fix its location. The outer circle represents the horizon. The inner circle is a location 45 degrees from the horizon. The number of each overhead satellite is shown. The strength of each satellite signal is shown. If the unit cannot establish a satellite fix, a list of solutions appears. Highlight the appropriate solution, and press ENTER. eTrex HC series Owner's Manual