GE JP389BJBB Use and Care Manual - Page 27
Cleaning, continued, Glass, Surface - black
UPC - 084691123736
View all GE JP389BJBB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
GEAppliances.com Cleaning the Radiant Module (continued) Burned-On Residue WARNING: DAMAGE to your glass surface may occur if you use scrub pads other than BLUE Scotch-Brite ® Multi-Purpose No Scratch scrub pads by 3M. 1. Allow the radiant module to cool. 2. Spread a few drops of Cerama Bryte ®to the entire burned residue area. 3. Using the Scotch-Brite blue pad, rub the residue area, applying pressure as needed. ® Scotch-Brite _ Multi-Purpose No Scratch blue scrub pad 4. If any residue remains, repeat the steps listed above as needed. 5. For additional protection, after all residue has been removed, polish the entire surface with Cerama Bryte ® and a paper towel. Heavy, Burned-On Residue 1. Allow the radiant module to cool. 2. Spread a few drops of Cerama Bryte ®to the entire burned residue area. 3. Hold the razor scraper at approximately a 45 ° The RAZOR SCRAPER is angle against the glass available through our Parts surface and scrape the Center. See instructions under "To Order Parts" soil. It will be necessary section at right. to apply pressure to the razor scraper in order to NOTE: Razor blade is remove the residue. packed inverted for safety reasons. Prior to use, the blade must be rotated and 4. Keep a small amount of reinserted into slot. Do not cream on the residue as use a dull or nicked blade. you scrape. 5. After scraping with the razor scraper, use the Scotch-Brite ®blue pad to remove any remaining residue. 6. For additional protection, after all residue has been removed, polish the entire surface with Cerama Bryte ® and a paper towel. Metal Marks and Scratches 1. Be careful not to slide pots and pans across your radiant module. It will leave metal markings on the surface. These marks are removable using the cleaning cream with a Scotch-Brite ® blue pad and/or razor scraper. 2. If pots with a thin overlay of aluminum or copper are allowed to boil dry, the overlay may leave black discoloration on the surface. This should be removed immediately before heating again or the discoloration may be permanent. WARNING: Carefully check the bottom of pans for roughness that would scratch the radiant module. Glass Surface - Potential for Permanent Damage Our testing shows that if you are cooking high sugar mixtures such as jelly or fudge and have a spillovel. it can cause permanent damage to the glass smface unless the spillover is immediately removed. Damage from Sugary Spills and Melted Plastic 1. Turn off all surface units. Remove hot pans. 2. Wearing an oven mitt: a. Use the razor scraper to move the spill to a cool area on the radiant module. b. Remove the spill with paper towels. 3. Any remaining spillover should be left until the surface has cooled. 4. Don't use the radiant module again until all of the residue has been completely removed. NOTE: If pitting or indentation in the glass surface has already occurred, the radiant module glass will have to be replaced. In this case, service will be necessary. To Order Parts To order Cerama Bryte ® and the razor scraper, please call our toll-free number: National Parts Center 800.626.2002. Cerama Bryte ® Cream ...... Razor Scraper Kit # WX 10X300 # WXSX1614 # WB64X5027 (Kit includes cream and razor scraper) 27