GE PFDS455GLMG Use and Care Manual - Page 35
Remove The Door Assembly, Disassemble The Door Assembly, Before You Start, Remove The Door Assembly
![]() |
UPC - 084691226642
View all GE PFDS455GLMG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Installation Instructions REVERSING THE DOOR SWING (if desired) BEFORE YOU START Unplug the dryer from its electrical outlet. 1 REMOVE THE DOOR ASSEMBLY (cont.) Close and hold the door, remove the 2 hinge screws (#10 x 0.75″ tapping screws). Pull the door away from the dryer front panel. 1 REMOVE THE DOOR ASSEMBLY Remove the side hinge cap by opening the dryer door and removing the screw from behind the hinge (#8 x .375″ tapping screw). Then using your hand, pop the hinge cap off the dryer. 1 x C Screw 2 x B Screws 2 DISASSEMBLE THE DOOR ASSEMBLY Lay the door down on a soft, protected, flat surface so that the inner part faces upward (door resting on the handle side). Remove the 7 screws (#10 x 1.125″ tapping screws) located around the perimeter of the door. 7 x A Screws Hinge cap Turn the door assembly over and separate the chrome cover from the inner door. Put the inner door aside on a soft, protected flat surface. 35
![](/manual_guide/products/general-electric-pfds455glmg-use-care-manual-5f13dc3/35.png)