GE PFDS455GLMG Use and Care Manual - Page 38

Installation Instructions REVERSING THE DOOR SWING (if desired) REVERSE HINGE AND CAPS (CONT.) • Assemble the hinge to the opposite side of the inner door, using 4 screws (#8-32 x 0.50″ machine screws). • Assemble the new inner door cap (from reversibility kit) on the opposite side of the hinge, using 2 screws (#8 x 0.75″ tapping screws). • Install the the screws, nuts and washers on the opposite side of the hinge in the 2 remaining holes. Replace 2 x D screws Inner door cap Replace 2 screws, 2 nuts and 2 washers Replace 4 x E screws Hinge 5 REASSEMBLE DOOR ASSEMBLY Turn the inner door over and place on a soft, protected flat surface so that the inner part is facing down. Assemble the chrome cover to the inner door by placing them together. Flip the door assembly over and assemble, using 7 screws (#10 x 1.125″ tapping screws). 7 x A Screws • Flip the inner door so that the inner part faces down. Assemble the inner cover (mask), be sure the snaps have clamped the inner cover. Assemble the outer window, be sure the 2 snaps have clamped the outer window. Outer window Snap 6 REVERSE FRONT PANEL PLUG BUTTONS AND STRIKE PLATE Remove the 2 plug buttons on the dryer front panel, using a putty knife or other flat tool as shown, and reinstall on the opposite side. Switch the strike bracket and its cover by removing 2 screws (#8 x 0.625″ tapping screws) for each and reinstalling on opposite sides. 2 Plug buttons Inner cover (Mask) Snap Strike bracket Protective piece of tape NOTE: Apply a protective piece of tape to the side of the plug button where the putty knife blade will be inserted to prevent scratching. 38