GE PFDS455GLMG Use and Care Manual - Page 44
Install The Pedestal, To The Washer Or Dryer, Prepare The Pedestal
![]() |
UPC - 084691226642
View all GE PFDS455GLMG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Installation Instructions 2 PREPARE THE PEDESTAL A Pull the drawer out as far as it will go. B Remove screws from drawer slides. Slide drawer out of the base and set aside. 3 INSTALL THE PEDESTAL TO THE WASHER OR DRYER A Place the pedestal against the bottom of the unit. Check to be sure the drawer front is at the front of the washer. B Align the holes in the pedestal with the holes in the bottom of the unit. Use a Phillips screwdriver to install the 4 bolts through the pedestal and into the unit-do not tighten. FOR DRYERS ONLY: C Locate the 4 support pads from the parts package. Each pad has 2 protrusions that fit into the holes on top of the pedestal. Press the rubber pads into each set of corner holes on the top of the pedestal as shown. C Slide the pedestal toward the unit, until it is aligned front to back. Use a 7 mm socket wrench to securely tighten the bolts. NOTE: The support pads should be installed on the dryer only. DO NOT INSTALL THESE PADS ON THE WASHER PEDESTAL. 44
![](/manual_guide/products/general-electric-pfds455glmg-use-care-manual-5f13dc3/44.png)