Gigabyte GA-6UASL1 Manual - Page 23
F_PANEL2 Front Panel Header
View all Gigabyte GA-6UASL1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
14) F_PANEL2 (Front Panel Header) Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. 12 17 18 Pin No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 Signal Name HD+ PWR+ HD- PWR- NA SW+ NA GND NA NA NA NA NA NA LAN- PWR+ LAN+ NA Definition Hard Disk LED Signal anode (+) Power LED + Hard Disk LED Signal cathode(-) Power LED Signal cathode(-) No Connect Power Button No Connect Ground No Connect No Connect No Connect No Connect No Connect No Connect LAN active LED Signal cathode(-) Power LED Signal anode (+) LAN active LED Signal anode (+) No Connect The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. - 23 - Hardware Installation