HP 4150 HP OmniBook 2100 - Docking Products User Guide - Page 23

To create a docked hardware profile

Get HP 4150 - OmniBook - PIII 500 MHz PDF manuals and user guides
UPC - 725184276088
View all HP 4150 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Using the Dock To create a docked hardware profile When Windows NT 4.0 was installed on your system, a hardware profile was created. If you do not already have a docked profile, you can copy this original profile and customize it for your docked hardware profile. 1. Double-click the System option in the Control Panel. 2. Click the Hardware Profiles tab. 3. Click the original configuration profile, then click Copy, and enter a name for your docked configuration. 4. Click Properties on the Hardware Profiles tabs 5. Check . on the General tab and click 6. Click OK to exit the Properties menu, then again to exit Hardware Profiles setup. 7. Shut down your Omnibook and dock it. 8. Reboot your OmniBook and select the docked profile from the list that appears at startup. 9. Click Settings, Control Panel, Devices and make sure all devices you need in the docked configuration are enabled. You may need to install drivers for additional devices used with the dock. Refer to the documentation provided with these devices for information. Refer to your Microsoft Windows NT documentation for more information about configuring hardware profiles and installing drivers. 1-23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
Using the Dock
9RHIVWXERHMRK±XLI±&EWMGW
1-23
To create a docked hardware profile
When Windows
NT 4.0 was installed on your system, a hardware profile was
created. If you do not already have a docked profile, you can copy this original
profile and customize it for your docked hardware profile.
1. Double-click the System option in the Control Panel.
2. Click the Hardware Profiles tab.
3. Click the original configuration profile, then click Copy, and enter a name for
your docked configuration.
4. Click Properties on the Hardware Profiles tabs
5. Check
8LMW²MW²E²TSVXEFPI²GSQTYXIV
on the General tab and click
²8LI²GSQTYXIV
MW²HSGOIH
.
6. Click OK
to exit the Properties menu, then
again to exit Hardware Profiles
setup.
7. Shut down your Omnibook and dock it.
8. Reboot your OmniBook and select the docked profile from the list that appears
at startup.
9. Click Settings, Control Panel, Devices and make sure all devices
you need in
the docked configuration are enabled.
You may need to install drivers for additional devices used with the dock. Refer to
the documentation provided with these devices for information.
2SXI
Refer to your Microsoft Windows NT documentation for more information about
configuring hardware profiles and installing drivers.