HP 6100 EMULEX EZPilot EVA Version 2.0 User Manual (5697-6961, July 2007) - Page 5

Installing EZPilot Introduction EZPilot™ from Emulex enables you to configure your Storage Area Network (SAN). This section describes how to: • Install EZPilot for a Windows EVA management server. • Install EZPilot for a Windows non-management server. • Install the Emulex Linux driver and utilities for a Linux non-management server. Prerequisites Operating System Requirements For Windows Management and Non-Management Servers: • x86 Windows Server 2003 Enterprise Edition Service Pack 2 • x64 Windows Server 2003 Enterprise Edition Service Pack 2 For Linux Non-Management Servers: • Red Hat Enterprise Linux 4 (latest update) • SUSE Linux Enterprise Server 9 (latest service pack) • SUSE Linux Enterprise Server 10 (latest service pack) Hardware Requirements Note: All servers must boot from a local disk. SAN boot is not supported by EZPilot. Single Switch Configuration (Non-redundant) • One Windows 2003 server configured as an EVA management server • Up to three non-management servers • One HP StorageWorks A8002A 4Gb PCI-e HBA per server • One HP StorageWorks Enterprise Virtual Array (EVA) 4100 storage system • One HP StorageWorks 4/8 Base SAN switch with eight licensed ports Additional non-management servers may be added if additional switch port licenses are purchased. Contact your HP representative for more information. EZPilot - Installation Section Page 1