HP Brio ba300 hp brio ba300, upgrade guide - Page 11

Upgrading and Replacing PC Hardware Removing and Replacing the Front Panel To Remove the Front Panel 1 With the cover removed, press in the two plastic clips on one side of the panel until the panel begins to come off. 2 Press in the two plastic clips on the other side of the panel until the panel is completely free. 3 Slide your hand in behind the front panel and carefully disconnect the status panel connector. status panel connector 4 Lay the front panel on a flat surface beside the PC. To Replace the Front Panel 1 Reconnect the status panel connector to the rear of the panel, taking care to connect it the right way round. 2 Insert the two plastic clips on one side of the panel then snap the panel into place. Note If the PC does not start properly or will not start at all, you may have reconnected the status panel connector wrongly. Remove the front panel and check the connection of the cable. 11