HP Brocade 8/12c Brocade Fabric OS Troubleshooting and Diagnostics Guide - Sup - Page 108
Displaying the uptime for a switch, TABLE 17
View all HP Brocade 8/12c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
10 Switch status The switchShow command also displays the following information for ports on the specified switch: TABLE 17 switchShow command output Variable Definition Index Slot Port Address Media Speed State Proto Index follows Area up to 255. Then it continues to the maximum port of the platform. Index identifies the port number relative to the switch. Index column is only displayed on enterprise-class platforms. Slot number 1-4 and 7-10. Port number 0-15, 0-31 or 0-47. The 24-bit Address Identifier. Address column is only displayed on enterprise-class platforms. SFP types used. The speed of the Port (1G, 2G, 4G, 8G, 10G, N1, N2, N4, N8, AN, UN). The speed can be fixed, negotiated, or auto-negotiated. The port status. Protocol support by GbE port. The details displayed for each switch differ on different switch models. For more information see the switchShow command in the Fabric OS Command Reference. To display the switch information, perform the following task. 1. Connect to the switch and log in as admin. 2. Enter the switchShow command. Displaying the uptime for a switch 1. Connect to the switch and log in as admin. 2. Enter the uptime command: ecp:admin> uptime 10:50:19 up 11 days, 6:28, 1 user, load average: 0.49, 0.53, 0.54 The uptime command displays the length of time the system has been in operation, the total cumulative amount of uptime since the system was first powered on, and the load average over the past one minute (1.29 in the preceding example), five minutes (1.31 in the example), and 15 minutes (1.27 in the example). The reason for the last switch reboot is also recorded in the system message log. 88 Fabric OS Troubleshooting and Diagnostics Guide 53-1002150-02