HP Brocade 8/12c Brocade Fabric OS Troubleshooting and Diagnostics Guide - Sup - Page 97
Zone conflicts
View all HP Brocade 8/12c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Zone conflicts 9 Symptom Symptom Symptom Symptom Zone conflict appears in logs and fabric is segmented. Probable cause and recommended action This issue is usually caused by incompatible zoning configurations. Verify the following are true: • The effective cfg (zone set) on each end of the segmented ISL is identical. • Any zone object with the same name has the same entries in the same sequence. Fabric segmentation is caused by a "configuration mismatch". Probable cause and recommended action Occurs when zoning is enabled in both fabrics and the zone configurations are different in each fabric. Fabric segmentation is caused by a "type mismatch". Probable cause and recommended action Occurs when the name of a zone object in one fabric is also used for a different type of zone object in the other fabric. A zone object is any device in a zone. Fabric segmentation is caused by a "content mismatch". Probable cause and recommended action Occurs when the definition in one fabric is different from the definition of a zone object with the same name in the other fabric. Zone conflicts Zone conflicts can be resolved by saving a configuration file with the configUpload command, examining the zoning information in the file, and performing a cut and paste operation so that the configuration information matches in the fabrics being merged. After examining the configuration file, you can choose to resolve zone conflicts by using the cfgDisable command followed by the cfgClear command on the incorrectly configured segmented fabric, then enter the cfgSave command followed by the portDisable and portEnable commands on one of the ISL ports that connects the fabrics. This causes a merge, making the fabric consistent with the correct configuration. ATTENTION Be careful using the cfgClear command because it deletes the defined configuration. Table 14 summarizes commands that are useful for debugging zoning issues. TABLE 14 Commands for debugging zoning Command Function aliCreate aliDelete cfgCreate cfgShow cfgDisable Use to create a zone alias. Use to delete a zone alias. Use to create a zone configuration. Displays zoning configuration. Disables the active (effective) configuration Fabric OS Troubleshooting and Diagnostics Guide 77 53-1002150-02