HP Dc5850 Technical Reference Guide: HP Compaq dc5850 Series Business Desktop - Page 95
Microcode Patch Error - bios update
UPC - 884962022993
View all HP Dc5850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Error Messages and Codes Table A-2. (Continued) Power-On Self Test (POST) Messages Error Message Probable Cause 514-CPU or Chassis Fan not detected. CPU fan is not connected or may have malfunctioned. 601-Diskette Controller Error Diskette drive removed since previous boot. 605-Diskette Drive Type Error Mismatch in drive type. 912-Computer Cover Removed Since Last System Start Up Cover (hood) removal has been detected by the Smart Cover Sensor. 914-Hood Lock Coil is not Connected Smart Cover Lock mechanism is missing or not connected. 916-Power Button Not Connected Power button harness has been detached or unseated from the system board. 917-Expansion Riser Not Detected Expansion (backplane) board not seated properly. 919-Front Panel, MultiPort, and/or Riser card has been removed or has not been reinstalled properly in MultiBay Risers not Detected the system. 1156-Serial Port A Cable Not Detected Cable from serial port header to I/O connector is missing or not connected properly. 1157-Front Cables Not Detected Cable from front panel USB and audio connectors is missing or not connected properly. 1720-SMART Hard Drive Detects Imminent Failure SMART circuitry on an IDE drive has detected possible equipment failure. 1721-SMART SCSI Hard Drive Detects Imminent Failure SMART circuitry on a SCSI drive has detected possible equipment failure. 1794--Inaccessible device attached A device is attached to SATA 1. Any device attached to this connector to SATA 1 will be inaccessible while "SATA Emulation" is set to "Combined IDE (for systems with 2 SATA ports) Controller" in Computer Setup. 1794-Inaccessible devices attached A device is attached to SATA 1 and/or SATA 5. to SATA 1 and/or SATA 5 (for systems with 4 SATA ports) Devices attached to these connectors will be inaccessible while "SATA Emulation" is set to "Combined IDE Controller" in Computer Setup 1796-SATA Cabling Error 1801-Microcode Patch Error Invalid Electronic Serial Number One or more SATA devices are improperly attached. For optimal performance, the SATA 0 and SATA 1 connectors must be used before SATA 2 and SATA 3. A processor is installed for which the BIOS ROM has no patch. Check for ROM update. Electronic serial number has become corrupted. Technical Reference Guide www.hp.com A-3